Smooth Fitness 2 HOW TO MAINTAIN YOUR SMOOTH 6.17 TREADMILL: ,

25 6.17MOTORIZDTREADMILL



MAINTENANCE

HOW TO MAINTAIN YOUR SMOOTH 6.17 TREADMILL:

Proper maintenance is very important to ensure your treadmill is always in top working condition. Improper

maintenance could cause damage or shorten the life of your treadmill and exceed the LIMITED WARRANTY

coverage.

• IMPORTANT:

Never use abrasives or solvents to clean the treadmill. To prevent damage to the computer, keep liquids

away and keep it out of direct sunlight.

• Inspect and tighten all parts of the treadmill regularly. Replace any worn parts immediately.

BELT ADJUSTMENT:

Belt adjustment and tension performs two functions: adjustment for tension and centering. The running belt has been

adjusted properly at the factory. However transportation, uneven flooring or other unpredicted reasons could cause the belt

to shift off center resulting in the belt rubbing with the plastic side rail or end caps and possibly causing damage. To adjust

the belt back to it’s proper position please follow the directions below:

• Walking belt has shifted to the left:

First unplug the power cord from the surge protector. Using the hex key provided, turn the left rear roller adjustment

bolt 1/4 turn in the clockwise direction. Plug the power cord back into the surge protector and run the treadmill at

2.5 mph. You should see the belt start to correct itself, moving back towards the center. Repeat the above

procedure until the walking belt is centered. It may be necessary to set walking belt tension once you have

completed this procedure if the belt feels like it is slipping while walking. Refer below to the "Walking belt slipping"

instructions.

• Walking belt has shifted to the right:

First unplug the power cord from the surge protector. Using the hex key provided, turn the right rear roller

adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the surge protector and run the

treadmill at 2.5 mph. You should see the belt start to correct itself, moving back towards the center. Repeat the

above procedure until the walking belt is centered. It may be necessary to set walking belt tension once you have

completed this procedure if the belt feels like it is slipping while walking. Refer below to the "Walking belt slipping"

instructions.

• Walking belt is slipping:

First unplug the power cord from the surge protector. Using the hex key provided, turn both the left and right rear

roller adjustment bolts the same distance, usually a 1/4 turn in the clockwise direction. Plug the power cord back

into the surge protector and run the treadmill at 2.5 mph. You should now walk on the belt to determine if the belt is

still slipping. Repeat the above procedure until the walking belt is not slipping. The tension should be just tight

enough not to slip.

WARNING! Do not over tighten rollers! This will cause premature roller bearing failure!

Right and left tension bolts are located at the rear of the treadmill..