Smooth Fitness CE2.0 user manual Training in Watt mode, Training in Body FAT mode

19

CE2.0 Crosstrainer

Training in WATT mode:

The preset value 120 is flashing on screen in WATT setting mode, select UP/DOWN/ENTER to set target value from 10 to 350. Pressing

Training in BODY FAT mode:

You may test and have the BODY FAT advice when the computer is in STOP mode. Please follow the steps as below:

Step I – Make sure the personal data has been input properly

Step II – Press BODY FAT button and hold on handgrip to start body fat testing.

Step III – The symbol “-------“ will appear on the display during the testing period of 8 seconds. After 8

seconds you will see the BADY FAT advice in percentage (*1) and BMI (*2) and the fat advice in a different symbol. It is possible that another indicator appears if the following situation occurs

a.“ E1” – When you see this indication, it means you did not put your thumb properly on the sensor. Please try again.

b.“E2” – When you see this indication, it means the BADY FAT advice is exceeded the available area which is fixed in the program.

After BODY FAT testing, press the BODY FAT button. The computer will continue from the previous data before testing. The BODY FAT advice figure and BMI will disappear. The computer will allow other users to test BODY FAT when in the STOP mode. The user can press RESET button for 4 seconds to select new user identification and input new personal data. Then follow each step as above to do the new testing.

www.smoothfitness.co.uk