Snapper 020231-2 manual How to Stop Your Pressure Washer, PSI Pressure Washer

Models: 020231-2

1 40
Download 40 pages 31.25 Kb
Page 11
Image 11
How to Stop Your Pressure Washer

3000 PSI Pressure Washer

10.Move variable pressure control lever to “High” position, shown on engine as a rabbit (Figure 11).

Figure 11 - Variable Pressure Control Lever

11.When starting engine, position yourself as recommended in Figure 12 and start engine according to instructions given in engine operator’s manual.Also see operating instructions tag located on the pressure washer.

Figure 12 - Recommended Starting Position

WARNING

Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than you can let go.

Broken bones, fractures, bruises or sprains could result.

ALWAYS point gun in safe direction and squeeze spray gun trigger, to release pressure and avoid kickback each time, before starting engine.

When starting engine, pull cord slowly until resistance is felt and then pull rapidly to avoid kickback.

After each starting attempt, where engine fails to run, always point gun in safe direction and squeeze spray gun trigger to release high pressure.

Firmly grasp spray gun with both hands when using high pressure spray to avoid injury when gun kicks back.

1.Let engine idle for two minutes. WARNING

Running engines produce heat.Temperature of muffler and nearby areas can reach or exceed 150°F (65°C).

Severe burns can occur on contact.

Exhaust heat/gases can ignite combustibles, structures or damage fuel tank causing a fire.

DO NOT touch hot surfaces and avoid hot exhaust gases.

Allow equipment to cool before touching.

Keep at least 5 ft. (152 cm) clearance on all sides of pressure washer including overhead.

Code of Federal Regulation (CFR) Title 36 Parks, Forests, and Public Property require equipment powered by an internal combustion engine to have a spark arrester, maintained in effective working order, complying to USDA Forest service standard 5100-1C or later revision. In the State of California a spark arrester is required under section 4442 of the California Public resources code. Other states may have similar laws.

How to Stop Your Pressure Washer

1.Let engine idle for two minutes.

2.Turn engine off according to instructions given in engine operator’s manual.

3.ALWAYS point gun in a safe direction and squeeze spray gun trigger to release retained high water pressure.

IMPORTANT: Spray gun traps high water pressure, even when engine is stopped and water is disconnected.

4.Engage trigger lock on spray gun when not in use. WARNING

The high pressure stream of water that this equipment produces can pierce skin and its underlying tissues, leading to serious injury and possible amputation.

Spray gun traps high water pressure, even when engine is stopped and water is disconnected, which can cause injury.

Keep high pressure hose connected to pump and spray gun while system is pressurized.

ALWAYS point gun in safe direction and squeeze spray gun trigger, to release high pressure, every time you stop engine. Engage trigger lock when not in use.

4.Engage trigger lock on spray gun when not in use.

11

Page 11
Image 11
Snapper 020231-2 manual How to Stop Your Pressure Washer, PSI Pressure Washer, Severe burns can occur on contact