Snapper 020231-2 How to Use Accessory Tray, How to Use Spray Tips, Cleaning and Applying Chemical

Low Pressure

Black

Use to apply

chemical

High Pressure

3000 PSI Pressure Washer

How to Use Accessory Tray

The unit is equipped with an accessory tray with places to store your spray gun and nozzle extension.There is also a hook at the front of the accessory tray to hold your high pressure hose.

NOTE: The extra hole in the tray is for storing a utility brush.The extra clip in the tray is for storing a turbo nozzle.The brush and turbo nozzle are NOT included with your pressure washer.You can buy these items as optional accessories.

1.Place nozzle extension through hole on accessory tray, as shown in Figure 13.

Figure 13 — Typical Accessory Tray

2.Place spray gun through hole on accessory tray on right side of unit (Figure 13).

3.Hang high pressure hose on hook attached to accessory tray on front of tray, as shown in Figure 13.

How to Use Spray Tips

The quick–connect on the nozzle extension allows you to switch between four different spray tips.The spray tips vary the spray pattern as shown (Figure 14).

CAUTION

A pressure washer produces a high pressure spray which increases risk of injury and damage to unit.

•NEVER exchange spray tips without engaging the safety latch on the spray gun trigger.

Follow these instructions to change spray tips:

1.Engage trigger lock on spray gun.

2.Pull back collar on quick–connect and pull current spray tip off. Store spray tips in holder provided on the nozzle extension.

3.Select desired spray tip:

•For gentle rinse, select white 40° spray tip.

•To scour surface, select yellow 15° or red 0° spray tip.

•To apply chemical, select black spray tip.

Figure 14 — Spray Tip Spray Patterns

	15° Yellow	0° Red
40° White

4.Pull back on collar, insert new spray tip and release collar. Tug on spray tip to make sure it is securely in place.

5.For most effective cleaning, keep spray tip from 8 to

24 inches away from cleaning surface. If you get spray tip too close, you may damage cleaning surface.

6.DO NOT get closer than 6 inches when cleaning tires.

Cleaning and Applying Chemical

IMPORTANT: Use soaps designed specifically for

pressure washers. Household detergents could damage the pump.

CAUTION

You must attach all hoses before you start the engine.

•Starting the engine without all the hoses connected and without the water turned ON will damage the pump.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

To apply detergent follow these steps:

1.Review spray tip use.

12