Snapper 020231-2 Assembly, Preparing Pressure Washer For Use, Remove Pressure Washer From Carton

3000 PSI Pressure Washer

ASSEMBLY

IMPORTANT: Read entire operator’s manual before you attempt to assemble or operate your new pressure washer.

Remove Pressure Washer From Carton

1.Remove parts bag packed with pressure washer.

2.Slice two corners at end of carton from top to bottom so panel can be folded down flat, then remove all packing material.

3.Roll pressure washer out of carton.

Carton Contents

Items in the carton include:

•Main Unit

•Safety Goggles

•Handle

•Plastic Accessory Tray

•High Pressure Hose

•Spray Gun

•Nozzle Extension with Quick Connect Fitting and Spray Tip Holder

•Oil Bottle

•Parts Bag (which includes the following):

•Operator’s Manual

•Engine Operator’s Manual

•Owner’s Registration Card

•Bag containing 4 multi–colored Quick Connect Spray Tips

•Handle Fastening Hardware Kit (which includes):

•Carriage Bolts (2)

•Plastic Knobs (2)

•Tree Clips (4)

PREPARING PRESSURE WASHER FOR USE

If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the pressure washer helpline at 1-800-317-7833.

To prepare your pressure washer for operation, you will need to perform these tasks:

1.Fill out and send in registration card.

2.Attach handle to main unit, then attach accessory tray to handle.

3.Add oil to engine crankcase.

4.Add fuel to fuel tank.

5.Connect high pressure hose to spray gun and pump.

6.Connect water supply to pump.

7.Attach nozzle extension to spray gun.

8.Select/attach quick connect spray tip to nozzle extension.

Attach Handle and Accessory Tray

1.Place handle onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 1).

Figure 1 — Attach Handle to Base

Handle

Align Holes

Handle

Supports

NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.

7