Snapper 1687262 installation instructions Connect Tube to Cover and Boot

Installation Instructions Tube and Latch Kit

	C
	E
	C
	H
F	G
	C
D
D	G
D
	F
	B
	A
	D

Figure 9. Install “U” Tube

A.“U” Tube

B.Channel Assembly

C.Carriage Bolts, 5/16-18 X 1-3/4

D.Nuts, Nyloc, 5/16-18

E.“L” Channel

F.Saddle Brackets

G.New 11/32 Holes

H.Capscrew, 5/16-18 x 3/4

8.Install the “U” tube (A, Figure 9) and “L” channel (F) to channel assembly (B) securing with 5/16-18 x 3/4 carriage bolts (C) and 5/16-24 nuts (E).

9.Using the “L” channel as a guide drill two 11/32 holes

(G) in “U” tube (A) as shown. Install 5/16-18 x 1-3/4 carriage bolts (C) through new holes (G) and secure with saddle clamps (F) and 5/16-18 locknuts (D) and 5/16-18 nuts (E).

10.Install 5/16-18 x 3/4 capscrew (H) and 5/16-18 lock- nut (D) as shown.

Connect Tube to Cover and Boot

1.Slide discharge tube (A, Figure 10) into seal (B). It may be necessary to lengthen several slits (C) in order for tube (A) to fit into seal (B)

2.Install boot according to Operator’s Manual.

C

A

B

Figure 10. Install Tube in Cover

A.Tube

B.Seal

C.Slits

B

C

D

A

Figure 11. Install Discharge Tube to Boot

A.Boot

B.Discharge Tube

C.Metal Puck

D.Wire Form

3.Attach the discharge tube (B, Figure 11) to boot (A) and secure the tube by moving wire form (D) down over metal puck (C).

4.Reverse connection to remove discharge tube.

MANUFACTURING, INC .		Form No. 1733418-01
	4	Rev. 5/2006
500 N Spring Street / PO Box 997		© 2006 Simplicity Manufacturing, Inc. All Rights Reserved
Port Washington, WI 53074-0997 USA		TP 200-4298-01-SK-SMA