Snapper 2400 XL manual Mulch Plug Installation & Removal Some Models, Volt Power Outlet

Operating the Tractor

MULCH PLUG INSTALLATION & REMOVAL (SOME MODELS)

1.Secure plate (B, Figure 12) to the mulch plug (A) using 1/4-20 x 3/4 capscrews (D) and 1/4 lockwash- ers (C).

WARNING

For your personal safety, do not handle the sharp mower blades with bare hands. Careless or improper handling of blades may result in serious injury.

C D

A

C

B

2.Remove the mower deck from the unit. See the unit’s Operating Instructions.

3.Insert mulch plug assembly (A, Figure 13) into dis- charge (B) from the under side of the mower deck.

Figure 12. Install Plate to Mulch Plug

A.	Mulch Plug	C. Lockwashers
B.	Plate	D. Capscrews, 1/4-20 x 3/4

4.Secure mulch plug (A, Figure 14) by sliding latch lever into (C) into mulch plug (A) as shown. Slide latch all the way in.

5.Reinstall mower deck onto unit. See the unit’s Operating Instructions.

6.Removal is reverse of installation.

12 Volt Power Outlet

CAUTION

Avoid Injury. Safe operation requires your full attention. Do not wear radio or music headphones while operating machine.

The 12-volt accessory plug is located in the left side pod (D, Figure 2). It can be used to power small electronic devices. The accessory must be rated at 14 amps or less.

Note: Operating a 12-volt accessory, especially with the engine at idle, may cause battery discharge. When not using the accessory plug it must be covered with the rub- ber plug to prevent moisture from causing a short circuit. Entrance of water into plug can cause a short circuit.

B

A

Figure 13. Install Mulch Plug

A. Mulch Plug B. Discharge

C

A

B

Figure 14. Install Latch Lever

A. Mulch PlugC. Latch Lever

B. Discharge

18