Section 2 - OPERATING INSTRUCTIONS
2.4 STOPPING - ENGINE, WHEEL DRIVE, BLADE 2.4.4. PARK BRAKE
1.Engage park brake by pushing clutch/brake pedal “DOWN” and moving the park brake latch to the “ENGAGED” position. While holding the park brake latch “ENGAGED”, release clutch/brake pedal to set park brake. See Figure 2.16.
2.5.CUTTING HEIGHT ADJUSTMENT
1. Adjust cutting height as desired to any one of five positions using deck lift lever. Move deck lift lever up or down to desired cutting height and then move over to secure in the height of cut notch. See Figure 2.18.
WARNING
DO NOT park the machine on slopes.
CLUTCH/BRAKE
PEDAL
PARK BRAKE
LATCH SHOWN
ENGAGED
FIGURE 2.16
2.Release park brake by pushing down on the clutch/brake pedal, parking brake latch will move to the “OFF” position unassisted. See Figure 2.17.
CLUTCH/BRAKE
PEDAL SHOWN
DISENGAGED
HEIGHT OF CUT
NOTCHES
DECK LIFT
LEVER
FIGURE 2.18
PARK BRAKE
LATCH SHOWN
IN “OFF”
POSITION
FIGURE 2.17
11
