Regular Maintenance
Deck Rod Timing Adjustment
1. Park the machine on a flat, level surface. Disengage the PTO, engage the parking brake, turn off the engine, and remove the ignition key. Rear tires must be inflated to 15 psi (1,03 bar); front tires to 25 psi (1,72 bar).
2. To check the lift rod timing, measure and record the distance between the lift pivots and the rod pivots. Repeat for other side of unit. See Figure 38.
3. If the measurements for the rods are equal, no further |
|
adjustment is required. If the measurements are NOT |
|
equal (greater than 1/8” (3,17 mm) difference), | Figure 38. Check Lift Rod Timing |
adjustment is required continue with Step 4. |
4.Lock the deck lift pedal in the 5” (12,7 cm) position. Remove the cutting height adjustment pin and lower the mower deck.
5.To ensure that the deck is in the lowest position, push the pedal by hand towards the rear of the unit and install the height adjustment pin in the 3” (7,6 cm) position to
hold in place.
6. Block up the mower deck until all hanger chains are slack. Refer to Figure 40.
7.See Figure 39. To adjust the lift rod, loosen the jam nut on the front clevis then remove the 1/2” clevis pin fastening the clevis to the lift pivot arm. Turn the clevis clockwise to shorten the distance between the rod pivots or counterclockwise to lengthen the distance between the rod pivots. Reinstall the clevis on the lift pivot arm and secure with the 1/2” clevis pin previously removed. Tighten the jam nut against the clevis.
8.Remove the blocks from the under the mower deck.
9.Remove the cutting height adjustment pin from in front of the deck lift pedal arm. Lift mower deck and reinstall adjustment pin in desired mowing height.
Deck Leveling Adjustment
NOTE: Before adjusting the deck level, the deck lift rod timing must be checked and/or adjusted.
1.Park the machine on a flat, level surface. Disengage the PTO, stop the engine and engage the parking brake. Rear tires must be inflated to 15 psi (1,03 bar); front tires to 25 psi (1,72 bar).
Figure 39. Adjust Lift Rod Timing
Figure 40. | 2 x 4 Locations |
Maintenance
2. Lock the deck lift pedal in the 5” (12,7 cm) position. 
Place the deck height adjustment pin in the 4” position
and lower the deck lift pedal until the arm contacts the pin.
3.Place 2 x 4 blocks under each corner of the mower deck with the
4.Adjust the front eyebolts until the chains are tight and the deck is still resting on the 2 x 4’s. Tighten the jam
nuts. See Figure 41.
5.Loosen the nuts and allow the rear of the deck to rest on the 2 x 4’s and 1/4” spacers. Slide the chains down in the slots until the chains are tight and tighten the nuts. See Figure 41.
6. Remove all 2 x 4 blocks and spacers from under the | Figure 41. Hanger Chain Adjustment |
| |
mower deck. |
|
35
