Operation
IDLE SPEED
Use the “low” position on the throttle lever to reduce stress on the engine when tilling is not being performed. Lowering the engine speed to “idle” will help extend the life of the motor, as well as conserve fuel and reduce the noise level of the equipment.
OPERATING SPEED
For normal tilling, set the throttle lever to “fast”.
SHUTTING DOWN
To stop the engine at any time, move throttle control to the off position. To stop wheels and tines at any time, release drive safety control levers to neutral position.
TILLING
1. Adjust the depth regulator lever to desired tilling depth.
!WARNING
TEMPERATURE OF MUFFLER AND NEAR BY AREAS MAY EXCEED 150F. AVOID THESE AREAS.DO NOT MOVE CHOKE CONTROL TO CHOKE TO STOP ENGINE. BACKFIRE OR ENGINE DAMAGE MAY OCCUR.
TO STOP WHEELS AND TINES AT ANY TIME, RELEASE DRIVE SAFETY CONTROL LEVERS TO NEUTRAL POSITION.
ALWAYS RELEASE DRIVE SAFETY CONTROL LEVERS TO NEUTRAL POSITION BEFORE ADJUSTING THE DEPTH OF THE REGULATOR LEVER.
NOTE: Raise depth regulator lever up one hole at a time, | ! DANGER | ||
testing tiller operation after each raise. Raising depth | |||
regulator lever too high can result in loss of control of | ENGINE AND SURROUNDING PARTS BECOME | ||
tiller! |
|
| |
|
| EXTREMELY HOT DURING NORMAL USE AND WILL | |
|
|
| |
2. Move the throttle control to fast. |
|
| CAUSE SERIOUS BURN INJURIES IF TOUCHED |
3. Place the tiller in forward by pushing down on the drive safety | BEFORE THE ENGINE HAS COOLED. | ||
| |||
control lever labeled | ALLOW ENGINE TO COOL COMPLETELY BEFORE | ||
tines. |
|
| TOUCHING THESE HOT SURFACES. |
NOTE: You can slow the tiller’s forward advance at any time |
| ||
| |||
by putting slight downward pressure on the handlebars.You |
| ||
|
| for |
|
can stop the tiller by releasing the drive safety c n r l levers | IMPORTANT | ||
to the neutral position. | Not |
| |
| PRACTICE OPERATING THE CONTROLS AND | ||
|
| ||
|
| TILLER WITH TINES OUT OF GROUND BEFORE | |
|
| BEGINNING TO TILL. IT IS IMPORTANT THAT YOU | |
|
| KNOW HOW TO USE THE TILLER PROPERLY, | |
|
| KEEP CONTROL AT ALL TIMES, STOP THE TINES | |
|
|
| |
|
|
| AND WHEELS FROM TURNING, AND STOP THE |
|
|
| ENGINE IF NECESSARY. IF YOU DO NOT KNOW |
|
|
| HOW TO DO THESE THINGS, READ THE CONTROLS, |
|
|
| ADJUSTMENTS AND SAFETY SECTIONS BEFORE |
|
|
| PROCEEDING. |
| Reproduction | ||
|
|
|
10