Section 3 - OPERATING INSTRUCTIONS
ROLL RELEASE: To roll the machine without the engine running, pressure within the hydraulic pumps must be released. There is a hydraulic pressure relief valve on the upper side of each pump that is used to release the pressure. Use a wrench to rotate both relief valves counter clockwise two full turns to open. After rolling machine, both relief valves must be rotated clockwise to close valves and tighten securely before operating machine. Machine will not move if relief valves are open. See Figure 3.4.
3.2STARTING & STOPPING - ENGINE, BLADES, PARKING BRAKE
3.2.1. STARTING ENGINE
When the ignition key is turned the engine will not start or turn over unless the blade switch is pushed in to the "OFF" position and the motion control levers are in the neutral lock position. Always engage parking brake before starting engine.
1.Complete
2.Sit in operator's seat.
3.Push blade switch in to "OFF", blades disengaged position and engage parking brake. See Figure 3.2.
4.Move choke control forward to choke position to start a cold engine. See Figure 3.5.
5.Move engine speed control to the Rabbit "FAST" position. See Figure 3.5.
6.Turn key to the start position until engine starts. See Figure 3.6.
NOTE: If after 5 seconds of cranking the engine does not start, release the key. Attempt starting again after waiting for approximately 20 seconds.
7.After engine starts, move the choke control to the "OFF" or no choke position. Allow a brief
ROTATE RELIEF VALVE |
|
|
|
|
COUNTERCLOCKWISE TO | CHOKE |
|
|
|
ENGINE SPEED |
|
| ||
RELIEVE PRESSURE |
|
| ||
CONTROL | CONTROL |
| KEY SWITCH | |
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| MOTION CONTROL |
|
|
|
|
|
| LEVERS SHOWN IN |
|
|
|
|
|
| THE NEUTRAL |
|
| RELIEF VALVE |
|
| |||
|
|
|
| LOCK POSITION |
| |
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| SHOWN FROM OPERATOR'S VIEW POINT | ||
| FIGURE 3.4 |
|
| FIGURE 3.5 | ||
|
|
|
|
| ||
|
|
|
|
|
|
|
! | WARNING | ! |
|
|
| |
DO NOT disengage the hydro transmission and coast down slopes. DO NOT use Roll Release Control to disengage the hydro transmission unless machine motion can be controlled and engine is off.
10
