
Section 4 - MAINTENANCE
4.3.3.RIDING MOWER - LUBRICATION 1. Front Wheel Bearings
Lubricate with Kendall NLGI No. 2 lithium grease or equivalent, from a grease gun. See Figure 4.5.
LUBRICATE |
| FRONT |
BEARINGS |
| WHEEL |
|
|
|
FIGURE 4.5
2.Hydro Pumps
Check the level of the fluid in the fluid reservoir. Wipe away all dirt and debris from around reservoir cap before removing. Oil must remain absolutely clean! Check with machine on a level surface with engine "OFF". Fill reservoir as needed to bring level up. The reservoir is properly filled when the fluid level is 1½" below the top of the filler neck. DO NOT OVER FILL. Use clean, fresh premium automotive oil having a vis- cosity equivalent to SAE 20W50 API SL. The fluid should be chemically stable, incorporating rust and oxidation inhibitors. Make sure funnels, pouring spouts and oil can are completely clean. Reinstall reservoir cap. See Figure 4.6.
3.Other Lubrication Points
Lubricate machine caster wheel shafts and traction idler arm with Kendall NLGI No. 2 lithium grease or equivalent, from a grease gun. See Figure 4.7.
4.4BEFORE OPERATING MACHINE
1.Clean all dirt and debris from around the hydraulic fluid reservoir, especially around the top and cap area.
2.Clean all dirt and debris from the cooling fins on the engine and from both hydraulic pumps.
4.5ANNUALLY (END OF EACH SEASON)
Perform all maintenance as described in Section "AFTER EVERY 25 OPERATING HOURS". Refer to Section "Service Schedule".
4.5.1. ENGINE
Service engine according to engine owner's manual.
HYDRAULIC FLUID
RESERVOIR
FIGURE 4.6
LUBRICATE
CASTER
WHEEL
| LUBRICATE TRACTION | |
| DRIVE IDLER ARM | |
| (GREASE FITTING | |
ELECTRIC | ||
LOCATED ON BOSS | ||
CLUTCH | ||
ABOVE IDLER ARM) | ||
| ||
|
FIGURE 4.7
(Continued on next Page)
16