Regular Maintenance

BC

D

Figure 10. Engine Compartment

A. Fuel Tank

B. Ignition Switch

C. Battery

D. Throttle / Choke Cable

E. PTO Switch (Electric Clutch)

A

I

H

F. Air Filter

EG. Oil Fill / Dipstick H. Fuel Filter

F

I. Oil Drain

 

G

RAISING THE SEAT DECK

To gain access to the engine compartment, simply tilt the seat deck forward.

ADDING FUEL

To add fuel:

1.Remove the fuel cap (A, Figure 10).

2.Fill the tank. Do not overfill. Leave room in the tank for fuel expansion. Refer to your Engine Manual for specific fuel recommendations.

3.Install and hand tighten the fuel cap.

FUEL FILTER

Do not use gasoline containing METHANOL, gasohol containing more than 10% ethanol, gasoline additives, premium gasoline, or white gas because engine/fuel system damage could result.

WARNING

The fuel filter is located in fuel line between fuel tank and carburetor. If filter is dirty or clogged, replace as follows. Place a container below filter to catch spilled gasoline.

1.Using a pliers, open and slide hose clamps from fuel filter.

2.Remove hoses from filter.

3.Install new filter in proper flow direction in fuel line. Secure with hose clamps. See warning at beginning of procedure.

OIL & FILTER CHANGE

Refer to Engine Manual.

CHECK / CHANGE AIR FILTER

Refer to Engine Manual.

REPLACE SPARK PLUG

Refer to Engine Manual.

Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area. Avoid over-filling and wipe up any spills.

Do not remove fuel filter when engine is hot, as spilled gasoline may ignite. DO NOT spread hose clamps further than necessary. Ensure clamps grip hoses firmly over filter after installation.

21

Page 21
Image 21
Snapper RE 200 manual Regular Maintenance