Snapper RE 200 manual Engine, Transmission, Chassis, Dimensions

Specifications

NOTE: Specifications are correct at time of printing and are subject to change without notice.

*The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive Engineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been

obtained and corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values are derived at 3600 RPM. Actual gross engine power will be lower and is affected by, among other things, ambient operating conditions and engine-to-engine variability. Given both the wide array of products on which engines are placed and the variety of environmental issues applicable to operating the equipment, the gas engine will not develop the rated gross power when used in a given piece of power equipment (actual "on-site" or net power). This difference is due to a variety of factors including, but not limited to, accessories (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for this Series engine.

ENGINE

13 HP* Intek OHV — Briggs & Stratton

Horsepower	13 HP @ 3400 rpm
Displacement	21	Cu. In. (344 cc)
Electrical	12	Volt, 3 Amp D.C. Battery 230 CCA
Air Cleaner	Pre-Cleaned Air to Paper Filter
Oil Capacity	3 Pints (1.42 L)

16 HP* Command™ — Kohler

Horsepower	16 HP @ 3400 rpm
Displacement	27.9 Cu. In. (460 cc)
Electrical	12 Volt, 15 Amp Alternator Battery: 230 CCA
Oil Capacity	4 Pints (1.9 L)

TRANSMISSION

Hydro Models

TypeHydrostatic

Lubrication Transmission is a Sealed Unit

Ground Speeds Infinite Forward: 0-5.2 MPH (0-8.4 km/h) Reverse: 0-2.3 MPH (0-3.7 km/h)

CHASSIS

Front Wheels Tire Size 13 x 5.00-6

Pneumatic Inflation Pressure 10 -12 psi (,68 - ,82 bar)

Rear Wheels Tire Size 16 x 6.50-8

Pneumatic Inflation Pressure 10 -12 psi (,68 - ,82 bar)

Fuel Tank Material: Non-Corrosive Polyethylene Capacity: 2 Gallons (7.5 L)

Turning Radius Inside Rear Tire 12 In. (30.2 cm)

DIMENSIONS

Overall Length	61 In. (155 cm)
Overall Width
- w/30 mower		38.5 In. (97.8 cm)
- w/34 mower		45.5 In. (115.6 cm)
- at rear wheels		33	In. (83.8 cm)
Height at
- steering wheel		41	In. (104.1 cm)
- seat back		35	In. (88.9 cm)
- engine cover		28	In. (71.1 cm)
Wheel Base		43	In. (109.2 cm)
Weight (appx.)
- 13 HP w/34”mower		Net: 405 lbs (183 kg)
- 16 HP w/34”mower		Net: 405 lbs (183 kg)

33