Snapper RE 200 manual Regular Maintenance, Maintenance Schedule & Procedures, Check Tire Pressures

Regular

Maintenance

MAINTENANCE SCHEDULE & PROCEDURES

The following schedule should be followed for normal care of your rider and mower.

SAFETY ITEMS	Before	Every 5	Every 25	Every	Every	Spring
	Each	Hours	Hours	100	250	& Fall
	Use			Hours	Hours
Check Safety Interlock System						•
Check Tractor Brakes						•
Check Mower Blade Stopping Time				•		•

TRACTOR MAINTENANCE ITEMS	Before	Every 5	Every 25	Every	Every	Spring
	Each	Hours	Hours	100	250	& Fall
	Use			Hours	Hours
Check Tractor/Mower for loose hardware		•
Lubricate Rear Axle Shafts						Yearly
Clean Battery & Cables				•
Check Tire Pressure			•
Clean Deck & Check/Replace Mower Blades**				•
Lubricate Rider & Mower				• ***
Transmission Maintenance *****
ENGINE MAINTENANCE ITEMS	Before	Every 5	Every 25	Every	Every	Spring
	Each	Hours	Hours	100	250	& Fall
	Use			Hours	Hours
Check Engine Oil Level	•
Check / Change Engine Air Filter *
Change Engine Oil & Filter *
Inspect Spark Plug(s) *
Check / Replace Fuel Filter *

*Refer to engine owner’s manual. Change original engine oil after initial break-in period.

**More often in hot (over 85° F: 30° C) weather or dusty operating conditions.

***Service after the first 50 hours of operation, then every 250 hours of operation.

****Service after the first 25 hours of operation, then every 250 hours of operation.

*****See you dealer.

CHECK TIRE PRESSURES

Tire Pressure should be checked periodically, and main- tained at the levels shown in the chart. Note that these pressures may differ slightly from the “Max Inflation” stamped on the side-wall of the tires. The pressures shown provide proper traction, improve cut quality, and extend tire life.

Tire	Pressure
Front	10-12 psi (,68 - ,82 bar)
Rear	10-12 psi (,68 - ,82 bar)	Figure 9. Checking Tire Pressure

20