2 safety rules regarding outdoor power equipment (cont.)
•Grass catcher components are subject to wear, damage, and deterioration, which could expose moving parts or allow objects to be thrown. Frequently check components and replace with manufacturer’s recommended parts, when necessary.
•Check brake operation frequently. Adjust and service as required.
•Use only factory authorized replacement parts when making repairs.
•Always comply with factory specifications on all settings and adjustments.
•Only authorized service locations should be utilized for major service and repair requirements.
•Never attempt to make major repairs on this unit unless you have been properly trained. Improper
service procedures can result in hazardous operation, equipment damage and voiding of manufacturer’s warranty.
3 unit assembly
Note: Please refer to Parts List for correct part identification and placement. Parts list reference
numbers are called out by sheet number followed by reference number(s) on that sheet: (1:1) indicates Sheet 1, reference number 1;
Note: Some assembly steps may already have been completed at the factory. Simply disregard factory- completed steps and proceed to the next assembly step.
CASTER ASSEMBLY
• Remove Lynch pin (1:16) and all but the bottom 1/4” spacer (1:15) from Caster horn (1:13).
• Slide Caster horn up through Caster arm (1:8), securing with same spacers and lynch pin removed in previous step. NOTE: When assembled in this manner, cutting height will be approximately
•With front of mower propped up, install caster assemblies to front of Blade Deck (1:1) with twelve 3/8" x 1" bolts, flat washers, and serrated flange nuts
GVTP
