Snapper XL Series manual Steering Gear Adjustment, Brake Adjustment

Troubleshooting, Adjustment, & Service

STEERING GEAR ADJUSTMENT

If there is excessive slack in the steering system, the steering gear backlash can be removed.

1.See Figure 30. Locate the steering gear assembly on the underside of the tractor. Loosen the two nuts and adjust the bracket so the gear teeth are closely meshed.

2.Tighten nuts to 36-44 ft. lbs. (49-59 Nm) after adjust- ment.

Nuts

Figure 30. Steering Gear Adjustment

BRAKE ADJUSTMENT
1. Disengage the PTO, stop the engine, block the
wheels, remove the ignition key, and engage the
parking brake.
2. Remove the mower deck (see Mower Deck
Removal).
3. Locate the brake spring (A, Figure 31) and adjust-
ment nut (B).	B
4. With the parking brake engaged, measure the com-
	A
pressed spring length. The spring should be 2-1/2”
(6,4 cm) when compressed.
If the spring is not within this range, turn the adjust-
ment nut (B, Figure 31) to compress or release the
spring.
If this adjustment does not correct a braking problem,
see your dealer.
	Figure 31. Brake Spring Adjustment
	A. Brake Spring
	B. Adjustment Nut

29