[ S N O M 4 S N A T F I L T E R ]
this is the first installation of the snom 4S proxy on this host from a RPM package please use the following command to install the software:
rpm -ihv snomnatf-2.10.*.rpm
If you already installed an older RPM version of the proxy please use the following command instead:
rpm
The output of both commands will just show some hashes (#) and then return to the command prompt without any message if no error occurred.
After you installed the software please load the file /etc/syscon- fig/snomnatf in your favorite editor and verify that you are satisfied with the default settings (SIP port: 5060, HTTP port: 80, Configuration direc- tory: /var/lib/snomnatf).
Note: during the installation values from /etc/rc.config or /etc/ natf.xml if they exists will be copied to /etc/sysconfig/snomnatf. The us- age of /etc/rc.config or /etc/natf.xml is deprecated and only the values from /etc/sysconfig/snomnatf will be considered for the future.
When you are satisfied with the configuration values please start the proxy with the following command:
/etc/init.d/snomnatf start
Note: the process will not be started automatically any more like it was with the old snom tarball installation, because user interactions are not possible during a RPM installation, but the port settings should be verified by the user before starting the process.
3.
