■Display symbols
Zero message
Idle indicator
Active range in the case of
Net weighing
Battery operation:
Replace battery respectively charge accu.
■ Malfunctions
Indicator | Remedy |
|
|
An acoustic signal confirms |
|
that entry was correct. |
|
Incorrect entries are indicated |
|
by 5 acoustic signals in swift |
|
succession. |
|
|
|
The scale sets the zero | Remove the items from |
value automatically when | the weighing platform. |
it is switched on. If the | Remove any dirt. Check |
scale is outside the | whether weighing platform |
tolerance range | is mounted duly. |
■Using the scale
Weighing
Switch on
(only when the scale is not loaded).
After the test routine, the main display is set to zero.
The scale is ready for use.
Place the items on the scale.
Manual zero resetting
When display does not show zero (scale unloaded). Manual zero reset- ting range see "Technical information".
Weighing with tare
Determine the tare of the empty container. Scales are ready to perform net weighing.
Deleting the tare weight
The gross weight appears in the dis- play or
Printer
Press key to print.
Your service partner can modify the printout.
Switch off
Possible immediately when display shows "0". During weight indication keep pressing for 3 seconds.
Underload: | Switch the scale off and |
Only the bottom horizontal | on again. The zero point |
lines appear on the display. | will be reset automatically |
|
|
Overload: | Remove some of the items to |
Only the top horizontal lines | be weighed from the scale. |
appear in the display. |
|
|
|
The zero setting range has |
|
been exceeded. |
|
Taring is not possible in |
|
case of over- and not |
|
loaded balance. |
|
Printing is not possible in |
|
case of over- or underloaded |
|
balance. |
|
Conversion to unit lb not |
|
admissible. |
|
|
|
| In case of all other error |
| indications: Please contact |
| your service partner. |
■Accu-/battery operation
At the bottom of the scale you can find the battery holder. 8 batteries "baby cells 1,5 C" or
tors of the same size are required. The lenght of opera- tion depends on the quality of the batteries or accumu- lators, e.g. at an accucapacity of 1,4 Ah appr.
resp. battery operation the background light of the display is switched off auto- matically.
If rechargeable batteries are not used for a longer time, they must be recharged every
If accumulators are used they cannot be recharged in the scale. Battery chargers are available in electronic stores.
| Message during | Remedy |
| battery operation | |
|
| |
|
|
|
| Residual length of |
|
| operation appr. 10 min. |
|
|
|
|
| Display shows | Change batteries or |
| recharge accumulators. | |
|
|
|
| Scale cannot be switched | Change batteries or |
| on during accu or battery | recharge accumulators. |
| operation. |
|
|
|
|
8 | 9 |
