Assembly
Required tools: phillips screwdriver (not included)
Align the foot bases with the bottom of the unit. Use the included bolts to attach the foot bases to the heater body as shown in the diagram.
Operation
PLEASE READ ALL INSTRUCTIONS BEFORE OPERATING HEATER!
1.Ensure that the Temperature Control Knob is at “OFF” position. [Fig 1]
2.Plug the power cord into a suitable electrical outlet. [Rated not less than 115 volt]
3.Turn the Temperature Control Knob clockwise until the Light Indicator turns on [Fig 2]. At this moment, the Temperature Control will start working.
Note: The Light Indicator will turn off when the room reaches the desired temperature. After a while, as the room temperature falls, the heater will turn on again and release heat until the room temperature rises to the desired temperature. Desired room temperature is maintained automatically by this procedure.
You can adjust the temperature control knob to increase or decrease the room temperature as desired by turning in a clockwise or