Soleus Air SG-TTW-09HC-26 manual Transportation Damage, Unpacking The Unit, Operating Instructions

IMPORTANT NOTE TO THE OWNER

This equipment is to be serviced by professionally trained personnel only. If this equipment is improperly installed, adjusted or altered by an unqualified person, a safety hazard may result.

IMPORTANT NOTE TO THE SERVICER

Read this manual and familiarize yourself with the specific items which must be adhered to before attempting to service this unit. The precautions listed in this manual should not supersede existing practices but should be considered as supplemental information.

Transportation Damage

All units are securely packed in shipping containers ap- proved by the National Safe Transit AssociationThe. carton should be checked upon arrival for external damage. If damage is found, immediately make a written request for inspection by the carrier’s agent.

In the event of damage:

1.Note on the delivery receipt any visible damage to shipment or container.

2.Notify carrier promptly and request an inspection.

3.File the claim with the following supporting documents within the six month statute of limitations.

a.Original Bill of Lading, certified copy, or indemnity bond.

b.Original paid freight bill or indemnity.

c.Original invoice or certified copy, showing trade and other discounts or reductions.

d.Copy of the inspection report issued by carrier’s representative at the time damage is reported to the carrier.

The carrier is responsible for making prompt inspection of damage and for a thorough investigation of each claimThe. distributor or manufacturer will not accept claims from dealers for transportation damage.

Unpacking The Unit

1.Cut the carton banding and open the carton.

2.Remove the literature, hardware pack, upper styrofoam shipping blocks, and styrofoam corner posts.

3.Remove the front assembly.

4.Lift the unit from the remaining carton.

5.Dispose of the cardboard and styrofoam at an approved Recycle Center. Check all contents for damaged or missing parts. In case of concealed damage, notify the carrier as soon as possible—preferably within 5 days. Refer to step 3 of theTransportation Damage section if damage or missing parts are noted.

Operating Instructions

Check the data specification plate and ensure the proper voltage and current rating for the type of power plug on the unit is available. DO NOT REMOVE THE GROUNDING PRONG FROM THE POWER CORD.See Figure 1 for the types of acceptable plugs. Do not use an extension cord for the installation of this product. Refer to the data specification plate for electrical requirements.

120V	240V	240V
15 amp	13 amp	18 amp
	Figure 1

•LCDI or AFCI Power Cords - Underwrites Laboratories and the National Electric Code (NEC) now require power cords that sense current leakage and can open the electrical circuit to the unit on units rated at 250 volts or less. In the event that unit does not operate, check the reset button located on or near the head of the power cord as part of the normal troubleshooting procedure.

LCDI power Cord

VOLTAGE MEASUREMENTS

Before connecting the unit, measure the supply voltage. Voltage must fall within the voltage utilization range given in Table 1.

Operating Voltage

Unit Voltage	Voltage Utilization Range
Rating	Minimum	Maximum
230/208	187	253
115	103	126

Table 1

Operating Voltage

1