Soleus Air SG-TTW-12HC-26 InstallationInstructions, Chassis Installation, Sleeve Installation

Models: SG-TTW-09ESE-26 SG-TTW-12ESEZ-26 SG-TTW-12HC-26 SG-TTW-09HC-26

1 17
Download 17 pages 12.58 Kb
Page 5
Image 5
CHASSIS INSTALLATION

InstallationInstructionsWARNING

To prevent electrical shock, property damage, personal injury, or death, do not remove grounding prong from plug. Follow all operating instructions.

CHASSIS INSTALLATION

1. Remove front grille. See Figure A.

Lift up on

Filter Handle

InstallationInstructions

To ensure that the unit operates safely and efficiently, it must be installed, operated, and maintained according to these installation and operating instructions and all local codes and ordinances, or, in their absence, with the latest edition of the National Electrical CodeThe. proper installation of this unit is described in the following sections. Following the steps in the order presented should ensure proper installa-

tion.

Figure A

 

SLEEVE INSTALLATION

The front grille can be removed for more thorough cleaning

or to make the model and serial numbers accessible. To

In order for condensate water to drain properly inside the unit, remove, pull the filter out and remove the two grille screws. the sleeve must be installed properly:

Level from right to left.

A slight downward pitch from the indoor side to the outdoor side as shown in Figure 3.

Refer to the Installation Instructions supplied with the wall sleeve for a complete description of the installation proce- dure.

NOTE: Wall sleeve (PBWS01A ) is not shipped with chassis and must be purchased separately.

Inside Outside Level

Wall

1/4 Bubble

Tilt To

Sleeve

Outside

 

SLEEVE INSTALLATION Outside

Wall

Figure 2

Grille

Inside Outside Level Tab

Pull the grille out from the bottom and lift up from the tabs on the top of the case.

2.Remove the grounding screw and wire next to the grounding symbol on right side of chassis control panel (Figure 3). Attach other end of ground wire to the hole in the bottom right side of the sleeve with #8 x 3/8” blunt point sheet metal screw. The hole on the sleeve is indicated by grounding symbol on the sleeve. Slide chassis part of the way into the sleeve and reattach the ground wire back to the hole on the right side on the control panel area next to the grounding symbol.

2

Page 5
Image 5
Soleus Air SG-TTW-12HC-26 manual InstallationInstructions, Chassis Installation, Sleeve Installation, Inside Outside Level