Solid State Logic 82BN0M01A, 82BN0M01B S OFT K EY C

Nucleus User Guide Page 25

SOFT KEY CONFIGURATION

The functions assigned to almost half of the switches on Nucleus are ‘soft’ and can be altered. This is done in the Soft Key

Setuparea at the bottom of the Remote’s DAW tab.

There are four Soft Key Setuppages, selected via the Soft Key Setbuttons in the

middle of the DAWtab – Default, User 1, User 2 and Transport / Utility.

The Defaultsoft keys are the 16 switches located above the channel displays on either side of Nucleus. The Defaultsoft key

set is active when neither of the centre section User keys are selected. The Mode switches on the left-hand side of Nucleus

are displayed in the top row, and the right-hand switches in the bottom row.

Mode switches 1-8 on the left-hand side come pre-assigned to the functions printed beneath them on Nucleus:

• The HUI protocol defaults are in white boxes

• The MCU protocol defaults are in white letters below the HUI defaults.

Mode switch 16 –labelled ‘KeybID’, on the far right-hand side –also comes pre-assigned, to the ‘Keyboard ID’ function. This

function is required for part of the USB set up as described in Section 4.

The upper row of buttons (left-hand Mode switches) can become menu selectors, accessing eight sub-functions assigned

to the lower row of buttons (right-hand Mode switches).

The User 1 and User 2 soft key sets are comprised of the Mode switches and the V-Sel switches in the right-hand channel

section (channels 9-16). There are two sets of User keys –User 1 and User 2– and they are accessed by pressing the User 1

or User 2switches in the centre section, beneath the Nucleus logo. The Mode switches can be run either as simple soft keys,

or as menu keys –each menu key accesses a subset of soft keys arranged across the V-Sel switches below.

An initial set of functions are assigned to the User 1soft key set in each of the default Profiles.