Solid State Logic 82BN0M01A, 82BN0M01B C HANNEL C

Page 34 Nucleus User Guide

CHANNEL CONTROL

On sessions with more than 16 channels, the CHANNELand BANK switches allow you to choose

which DAW channels are controlled by the 16 Nucleus faders.

To scroll the Nucleus th rough the DAW cha nnels in increments of one, use the left and right

CHANNEL switches. To scroll in increments of 16 DAW channels, use the left and right BANK

switches.

Note that a channel scrolling function can also be assigned to the Nucleus jog wheel via the Nucleus Remote. Select

TRACKSfor the Jog Wheel Default. See Page 24 for more details.

Logic users: Note that the tracks in the session may not appear on Nucleus in the order that they are displayed in the

ARRANGEwindow unless the ARRANGE Channel Strip View mode is selected in the Logic control surface set up menu.

The channel faders and the three switches above them are used for basic control of the DAW channels selected using the

CHANNELand BANK scrolling functions described above:

- The Nucleus fader controls the DAW channel fader

- The Nucleus CUTand SOLO switches control the DAW channel cut and solo functions.

Note that there is a DAW SOLO LED to the right of the Nucleus logo which lights whenever the solo function is active

within the DAW.

- The Nucleus SELswitch is used to select the channel in the DAW, for purposes such as channel naming. The switch lights

to indicate that it’s corresponding DAW channel is selected. It can also be used for track arming (by pressing the centre

section RECswitch – see below), automation (using the centre section AUTOswitch – see below) and for assigning plug-

ins to the Nucleus plug-in editor (using the centre section PARAMswitch – see Page 36).

DAW channel meters are replicated at the top of each Nucleus channel strip, above the Mode switch.

The channel SELswitches can be used as track arming switches. To do this, select the RECswitch above-left of the MONITOR

LEVELcontrol. You will notice that the SELswitches now light red and emulate the status of the channel record ready indicator.

Once the RECswitch is deselected, the RECLED just below the relevant channel meter lights to indicate ‘Record Ready’ status.

The DAW channel’s automation mode can be controlled by selectin g the AUTO switch above-left of the MONITOR LEVEL

control. Use the channel SEL switches to select which channel’s automation mode is being edited, then press the V-Sel

switches to trigger the mode shown in the lower row of the display above them. The upper row of the display will indicate the

selected mode for the selected channel.

Note that the automation modes can be accessed using the V-Sel switches in either side of Nucleus.

HUI Users: Single-letter indication of automation modes can be permanently displayed after the channel name in the

upper row of the display – this is determined by Show Auto Mo de in the DAW t ab of the Remote. Write modes are

indicated by a flashing

, read modes by a flashing

, and Off is indicated by no flashing letter. See the Nucleus Remote

Section for more information.