Sonance Sonamp ASAP3D SE Stereo Power Amplifier Appendix 2: IR Command List, Jumper, Variable

SO N A M P ® ASAP3D SE ST E R E O PO W E R AM P L I F I E R

Appendix 1: Changing the Mono Variable Output to a Fixed Output Level

The MONO VAR OUT is factory-set to Variable via a jumper on the amplifier PCB. To change the output to a fixed level (which is not affected by the front-panel L and R Input Level Controls or by IR volume commands):

1.Unplug the amplifier’s power cord from the Power Cord Connection on the back of the amplifier.

2.Remove the 8 screws (4 on top and 2 on each side) that secure the amp’s chassis cover.

3.Locate the MONO OUT section on the circuit board (see Figure 27).

4.Remove the jumper from the center pin and the “V” (variable) pin and re-insert it between the center pin and the “F” (fixed) pin (see Figure 28).

5.Replace the amplifier’s chassis cover and screws, and plug the power cord back into the Power Cord Connection.

Front

Panel

MONO OUT

Jumper

FIGURE 27: MONO OUT JUMPER LOCATION

Jumper	Jumper
Variable	Fixed
FIGURE 28: CHANGING THE JUMPER FROM FIXED TO VARIABLE

Appendix 2: IR Command List

The following ASAP3D SE functions can be controlled via IR:

• Amplifier ON (Local source active)	• Volume 0 (Jump to 0)
• Amplifier OFF (House source active)	• Volume 20 (Jump to 20)
• Mute ON	• Volume 40 (Jump to 40)
• Mute OFF	• Volume 60 (Jump to 60)
• Mute Toggle ON/OFF	• Volume 80 (Jump to 80)
• Volume –1 (Down one step)	• Volume 100 (Jump to 100)
• Volume +1 (Up one step)	• BBE ON
• Volume –3 (Down three steps)	• BBE OFF
• Volume +3 (Up three steps)	• BBE Toggle ON/OFF
• Volume –5 (Down five steps)
• Volume +5 (Up five steps)

13