When you select “DIST INFO” or“LEVEL INFO”

You can check the speaker distance or speaker level.

Note

•The measurement result of a speaker will not appear if the subwoofer does not recognize that the speaker is connected.

After you have finished

Disconnect the calibration mic from the subwoofer.

Note

•If you have changed the position of the speakers, Sony recommends that you perform the Auto Calibration again in order to enjoy the surround sound.

Deleting the result of the Auto Calibration

You can delete the result of the Auto Calibration. If there is no saved data, you cannot delete the result.

1 Press AMP MENU.2 Press x/X repeatedly until “A.CAL MENU” appears, then press or c.3 Press x/X repeatedly to select “A.CAL CLEAR,” then press or c.4 Press x/X to select “YES,” then press

.

The saved result is deleted.

The settings for speaker distance and speaker level return to their defaults.

Setting up the Sound Output of the Connected Component

Depending on the audio output settings of the connected component, the sound may output in 2 channel sound format only. In this case, set the connected component to output the sound in multi channel sound format (PCM, DTS, Dolby Digital). For details on audio output settings, refer to the operating instructions of the connected component.

28GB