Calibrating the

Appropriate Settings

Automatically

(AUTO CALIBRATION)

D.C.A.C. (Digital Cinema Auto Calibration) can set the appropriate surround sound automatically.

Note

•The system outputs a loud test sound when [AUTO CALIBRATION] starts. You cannot turn the volume down. Give consideration to children and neighbours.

•Make sure that the headphones are not connected to the surround amplifier. You cannot operate the following steps with the headphones connected.

•Before [AUTO CALIBRATION], be sure that the surround amplifier turns on and you install the surround amplifier in the appropriate location. If you install the surround amplifier in an improper location, such as another room, proper measurement will not be obtained.

1 Press FUNCTION repeatedly until “DVD” appears in the front panel display.

2 Press DISPLAY while the system is in stop mode.

The Control Menu display appears on the TV screen.

3 Press X/x to select [SETUP], then press .

The options for [SETUP] appear.

4 Press X/x to select [CUSTOM], then press .

The Setup Display appears.

5 Press X/x to select [AUDIO SETUP], then press .

The options for [AUDIO SETUP] appear.

6 Press X/x to select [AUTO

CALIBRATION], then press .

The options for [AUTO CALIBRATION] appear.

7 Connect the calibration microphone (supplied) to the ECM-AC2 jack on the rear of the control unit.

Set up the calibration microphone at the ear level using the tripod, etc. (not supplied). The front of each speaker should face the calibration microphone, and there should be no obstruction between the speakers and the calibration microphone.

Note

•The ECM-AC2 jack is used for the supplied calibration microphone only. Do not connect other microphones.

Rear of the control unit

To ECM-AC2 jack

Calibration microphone

8 Press C/c to select [YES].

9 Press .

[AUTO CALIBRATION] starts. Be quiet during the measurement.

88GB