Specifying the speaker parameters
To obtain the best possible surround sound, first specify the distance of the speakers from your listening position, then set the balance and level. Use the test tone to adjust the speaker volumes to the same level.
You may adjust the speaker parameters using SPEAKER SETUP in the setup display (page 70).
Started Getting
C/X/x/c/ENTER
AMP MENU
To specify the size, distance, position and height of the speakers
1 Press AMP MENU repeatedly to display 9 SP. SETUP on the front panel display. 2 Sit in your listening position and select the item to be set using X/x.
•Items set in 9 SP. SETUP
–Size of 5 speakers (front L/R, center, rear L/R)
–with or without the center and rear L/R speakers and subwoofer
–Distance of the front, rear, and center speakers
–Position and height of the rear speakers
3 Set the parameter using C/c.
The selected parameter will appear on the front panel display.
4 Repeat Steps 2 and 3 to set other parameters in 9 SP. SETUP.
If you do not operate the remote for a few seconds, the parameter disappears from the display and is stored in the receiver.
xSIZE
When you do not connect center or rear speakers or subwoofer, set the parameters for F.SP., C.SP., R.SP., and S.W. The default settings are underlined.
• F.SP. (front speaker)
–SMALL: Select this if the small speakers are used for the front speaker.
•C.SP. (center speaker)
| |
– SMALL: Select this if the small speaker is used for the center speaker. |
|
– NO: Select this if no center speaker is used. | continued |
|