Preparations for Using the Networking Function
You can connect this device to the network with a LAN cable
This section describes the tasks required for using the networking function of this device.
Installing this device
Before installation•Before installation, make sure that the power to all the equipment is off. To turn the display completely off, press the 1 switch so that the display changes to standby mode, then disconnect the power cord from the wall outlet.
•When you install this device, make sure that the flat panel display is locked and stable.
Follow the steps below to install this device to the FWD series Flat Panel Display.
1 Remove the installed option adaptor or the panel cover. (Refer to either of the following illustrations that applies to your Display unit.)
When the option slot is located on the left side of a Display unit*
INPUT 2 | RGB / COMPONENT |
| AUDIO |
OUT | L |
AUDIO | R |
1 |
|
IN | VIDEO |
| S |
OUT | ADAPTOR |
2 | VIDEO INPUT |
IN | |
OUT | VIDEO |
L AUDIO IN | |
R |
|
1 |
|
*The location of the option slot differs depending on the model of the Display unit. If your Display unit has more than one option slot, install the device in a COM port, a slot used for the network. Refer to the Operating Instructions for the
FWD series as well.