IV board

Return: Setting status of the return signal input connectors to the return channels from 1 to 3 Return Signal: Status of the return video input signal Rear CN: Power supply status of the CN board on the rear

PLD Config: Configuration completion status of the PLD mounted on the IV board

Power: Power supply status of the IV board

EN board

Component: Setting status of the component output signal from the OUTPUT connector and status of the sync signal added to the component Y/G output signal from the OUTPUT connector

Composite Out-1:Signal type from composite output connector 1 (VBS/SDI)

Composite Out-2:Signal type from composite output connector 2 (VBS/SDI)

Composite Out-3:Signal type from composite output connector 3 (VBS/SDI)

Composite Setup: Setup settings to be added to the VBS signal

Rear VDA: Power supply status of the VDA board on the rear

PLD Cofig: Configuration completion status of the PLD mounted on the EN board

Power: Power supply status of the EN board

Diagnostics Page of the Camera

The results of the diagnosis of each board of the camera are displayed.

Exiting the Self-diagnostic Mode

Display the last “ROM Version” page, and then press the CHARACTER button again.

When an Error Occurs

The error message is displayed on the picture monitor. In such a case, display the self-diagnostics page corresponding to the board where the error has occurred by pressing the CHARACTER button.

16 Self-Diagnostics