Function and Location of Parts and Controls

Front panel

aCamera number sheet/tally indicator

bPOWER switch/CAM and MAIN indicators c CABLE ALARM indicators

dINCOM input/output/setting section

aCamera number sheet/tally indicator

Lights red when the red tally signal is input (e.g. when the video signal from the video camera connected to the CCU-TX50/50P goes on air). When the CALL button on the unit or RCP-D50 remote control panel is pressed, the indicator lights red if it is not lit, and goes off if it is lit.

The indicator lights green when the green tally signal is input.

Attach the supplied number sheet here to indicate the camera number.

bPOWER switch/CAM (camera) and MAIN indicators

The POWER switch turns on or off the power supply to the entire camera system, including the CCU-TX50/ 50P, the video camera, and the remote control unit connected to the REMOTE connector on the CCU- TX50/50P.

The MAIN and CAM indicators light when the POWER switch is turned on.

The CAM indicator goes off when the power is turned off by the CAM PW button on the remote control panel.

Note

If the fan in the CCU-TX50/50P stops, the MAIN indicator will flash simultaneously to warn you of the abnormal condition. If this occurs, turn the POWER switch off immediately and contact Sony service personnel.

cCABLE ALARM indicators

OPEN: Lights when no triaxial cable is connected to the CAMERA connector on the rear panel of the CCU-TX50/50P, or when the load current is extremely low even when a camera cable is connected. SHORT: Lights when there is a current overflow in the triaxial cable.

dINCOM (intercom) input/output/setting section INCOM (intercom) connector (XLR, 5-pin)Connects a headset.

INCOM level control

Adjusts the input level of the headset.

MIC/PGM (program audio) switch

ON: Turns on the headset microphone.

Function and Location of Parts and Controls

5