Sony CD-DH790N operation manual Setting the clock Remote control only, Listening to the iPod

Setting the clock (Remote control only)

CD

USB

TAPE

In this example, the clock is set for the 24-hour (0:00) display.

1Press the ON/STAND-BY button to turn the power on.

2Press the CLOCK/TIMER button.

3Within 10 seconds, press the MEMORY button.

Press the or button to select 24-hour or

12-hour display and then press the MEMORY button.

Listening to the iPod

Supported iPod models:

●iPod nano (software 1.2 above)

●iPod mini (software 1.2 above)

●iPod (5th generation) (software 1.3 above) (Dock connector equipped Click Wheel model)

●iPod (4th generation) (software 3.0.2 above) (Dock connector equipped Click Wheel model)

●iPod nano (2nd generation) (software 1.0.0 above)

●iPod nano (3rd generation) (software 1.0.3 above)

●iPod nano (4th generation) (software 1.0.3 above)

●iPod classic (software 1.0.3 above)

●iPod touch (software 1.1 above)

●iPod touch (2nd generation) (software 2.1 above)

Caution:

Please update your iPod unit to the latest software version from Apple’s homepage before using it.

Notes:

●Once the iPod is connected to the unit it will begin charging.

●The iPod unit cannot be charged while the main unit is in the stand-by mode or during USB mode.

Auto power on function:

When you press any of the following buttons, the unit turns on.

● iPod button on the remote control: The unit turns on

“0:00”

The 24-hour display will appear. (0:00 - 23:59)

and the iPod function is activated.

● / button on the main unit: The unit turns on and

“AM 12:00” The 12-hour display will appear. (AM 12:00 - PM 11:59)

“AM 0:00” The 12-hour display will appear.

(AM 0:00 - PM 11:59)

4To adjust the hour, press the or button and

then press the MEMORY button. Press the or button once to advance the time by 1 hour. Hold it down to advance continuously.

5To adjust the minutes, press the or button and

then press the MEMORY button. Press the or button once to advance the time by 1 minute.

To confirm the time display:

Press the CLOCK/TIMER button. The time display will appear for about 10 seconds.

Note:

The “CLOCK” will appear or time will be displayed when the AC power supply is restored after a power failure or unplugging the unit. If incorrect, readjust the clock as follows.

To readjust the clock:

Perform “Setting the clock” from step 1. If the “CLOCK” does not appear in step 2, step 3 (for selecting the 24-hour or 12-hour display) will be skipped.

To change the 24-hour or 12-hour display:

1Clear all the programed contents. [Refer to “Factory reset, clearing all memory” on page 20 for details.]

2Perform “Setting the clock” from step 1 onwards.

playback of the last function will start (iPod, CD,

TUNER, USB, TAPE, AUDIO IN).

■ iPod adaptor connection

Notes:

●iPhone is not supported by this system.

●You can use an audio cable to connect your iPod to the AUDIO IN jack if:

1.your iPod adaptor does not fit into the iPod dock on the main unit.

2.you have an iPod that does not have an iPod adaptor.

3.you have an iPod that does not have an iPod 30 pin connector.

E-7