Sony CDP-CX153 16EN, Checking the programmed order, Changing the programmed order, You need to

Playing CDs

6Press ENTER.

The disc being programmed

DISCTRACKSTEP

￿ 2 0 ￿ ￿ 1 ￿ ￿ ￿ ￿ 1 ￿ ￿ ￿ ￿ ￿

PROGRAM 1 CD 1

The track being Playing order programmed

7To program other discs/tracks, do the following:

To program	Repeat Steps
Other discs	2, 3 and 6
Other tracks on the same disc	4 to 6
Other tracks on other discs	2 to 6

8Press (to start Program Play.

To cancel Program Play

Press CONTINUE.

The programs remain even after Program Play ends

When you press (, you can play the same program again.

When you press PROGRAM during Continuous or Shuffle Play

The program you played last time appears and will be played after the current track.

The programs remain until you erase them

If you replace discs, the programmed disc and track numbers remain. So, the player plays only the existing disc and track numbers. However, the disc and track numbers that are not found in the player or on the disc are deleted from the program, and the rest of the program is played in the programmed order.

Checking the programmed order

You can check your program before or after you start playing.

Press CHECK.

Each time you press this button, the display shows the disc and track number of each step in the programmed order. (When a whole disc is programmed as one step, “AL” appears instead of the track number.) After the last step in the program, the display shows “END” and returns to the original display.

Changing the programmed order

You can change your program before you start playing.

To	You need to
Erase a track or disc	Press CHECK until the track or
	disc you do not want appears in
	the display, then press CLEAR.
Erase the last track or	Press CLEAR. Each time you
disc in the program	press the button, the last track or
	disc will be cleared.
Add tracks or discs to the	Follow the programming
end of the program	procedure
Change the whole	Hold down CLEAR until “ALL
program completely	CLEAR” appears in the display to
	erase the whole program, then
	create a new program following
	the programming procedure.

Erasing the programs stored in memory

1Press PROGRAM repeatedly in the stop mode until the program number (PROGRAM 1, 2 or 3) you want to erase appears in the display.

2Hold down CLEAR until ”ALL CLEAR” appears in the display.

16EN