Getting Started

Turning off the player’s response to remote signals

To use the remote supplied with another component compatible with the 2 way remote system, you must turn off this player’s response to signals of the remote supplied with this player.

Set the 2 way remote system to off when:

•you use the remote as RM-TP501, RM-TP501E, RM-LJ301 supplied with the receiver/amplifier (you can operate Disc 1 to Disc 200 only).

•you use the remote with the mark supplied with the receiver/amplifier.

MENU/NO YES JOG

+100

I / u

1Press MENU/NO.

2Turning the JOG dial until “2WAY OFF ?” appears in the display window.

3Press YES.

When you connect the player to CDP-CX260 or CDP- CX88ES, press OPERATE on the transmitter/receiver to turn it off, and set the 2 way remote system of the player to on.

To return to normal setting

After following steps 1 and 2, and “2WAY ON ?” is displayed, then press YES.

Notes

•When you use the remote to operate more than one unit, position the units so that each unit can receive the signals of the remote.

•When you use this player with a receiver/amplifier, turn the receiver/amplifier on when using this player.

Setting Up the Remote

This section describes how to prepare the supplied remote for operation.

Press I/uon the player to turn the player on. If the following message appears in the remote’s display while setting up the remote, point the remote at the player as illustrated below.

Ca n ' t r e c e i v e

P l e a s e

t u r n

 

t h i s

REMOTE

t o a ma i n

u n i t

Note that the display disappears automatically if you don’t proceed for more than a few moments.

I/u

30°

 

PLAYER SELECT

 

 

TRACK MENU BACK

MENU

 

 

Easy scroll

PUSH ENTER

key

 

 

 

CONTINUE

SHUFFLE

 

PROGRAM

REPEAT

 

MEMO SCAN

DISC

 

 

SKIP

TIME/TEXT

6GB