5 Press (4) (n).

LP1

SUR EQ

R

F

6 Press (+) or (Ð) to adjust the center of the sound field to the front or rear.

Center moves to the F (front).

Center moves to the R (rear).

7 Press (SOUND) for two seconds. When the effect setting is complete, the normal playback mode appears.

Adjusting the fader (FAD)

Normally, with the DSP mode on, the volume of the output sound from the rear speakers is

EN lowered automatically to improve the efficiency of the listening position setting. If you want to raise the rear speaker volume, adjust the fader.

1 Follow steps 1 to 3 of “Selecting a surround menu” (page 13).
2 Press (SOUND) repeatedly until “FAD” appears.
3 Press (+) or (Ð) to adjust the fader.

Increases front speaker volume

Decreases front speaker volume

After three seconds, the display goes back to the normal playback mode.

16

Adjusting the volume of the subwoofer(s)

1 Press (SOURCE) to select a source (radio,

CD or MD).

2 Press (SOUND) repeatedly until “SUB” appears.

3 Press (+) or (Ð) to adjust the volume. After three seconds, the display goes back to the normal playback mode.

Adjusting the frequency of the subwoofer(s)

To match the characteristics of the connected subwoofer(s), you can cut the unwanted high and middle frequency signals entering the subwoofer(s). By setting the cut-off frequency (see the diagram below), the subwoofer(s) will output only low frequency signals so that you can get a clearer sound image.

Level

Cut-off frequency

 

 

62 125 198

Frequency (Hz)

1 Press (SOURCE) to select a source (radio,

CD or MD).

2 Press (SOUND) for two seconds.

3 Press (SOUND) repeatedly until “SUB” appears.

SUR EQ

COFF 125

4 Press (+) or (Ð) to select the desired cutoff frequency.

The cut-off frequency in the display changes.

62 n78 n99 n125* n157 n198 Hz

*Factory-set frequency

5 Press (SOUND) for two seconds.

When the frequency setting is complete, the display goes back to the normal playback mode.