Adjusting the volume of the bass and treble

You can adjust the volume of the bass and treble to best fit the acoustic characteristics inside your car.

1 Press (SOURCE) to select a source (radio,

CD or MD).

2 Press (SOUND) repeatedly until “BAS” or “TRE” appears.

3 Press (+) or (Ð) to adjust the volume. After three seconds, the display goes back to the normal playback mode.

Adjusting the turn-over frequency

You can adjust the bass and treble turn-over frequencies.

Turn-over frequency

Frequency (Hz)

1 Press (SOURCE) to select a source (radio,

CD or MD).

2 Press (SOUND) for two seconds.

3 Press (SOUND) repeatedly until “BAS” or

“TRE” appears. Bass adjusting mode

BAS

SUR EQ

314

Treble adjusting mode

TRE

31K

SUR EQ

4 Press (+) or (Ð) to select the turn-over frequency.

The turn-over frequencies change as follows:

Bass:

198 Hz n250 Hz n314 Hz* n396 Hz

Treble:

2.0 kHz n3.1 kHz* n4.0 kHz n5.0 kHz

*Factory-set frequency

5 Press (SOUND) for two seconds. The display goes back to the normal playback mode.

Listening to each program source in its registered surround menu

— Source Sound Memory

You can listen to the same source always in the same surround menu even after changing the program source or turning the unit on and off again.

Note

“LSM” (Last Sound Memory) appears on the TV display when you have selected a surround menu.

Changing the line output level
1 Press (SHIFT), then press (2) (SET UP) until “L.OUT” appears.
2 Press (4) (n) to select the desired setting (–10 dB or –16 dB).

EN

DSP

17