The height, width and depth of the virtual sound stage can be adjusted to your taste.
1Select “SOUND” t “DSO 3D” in
MENU mode.
2Select “Custom1,” “Custom2” or “Custom3” to store.
3Select “STD,” “Wide” or “Deep.”
In your chosen Custom setting the preset can
be adjusted, then a pencil icon will appear as
“Custom1” t “Custom1 | .” |
4Select one of the 3 parameter modes to adjust: “Elevation,” “Width” or “Depth.”
5 Adjust the position between 1 and 8.
6Confirm your settings using the confirmation screen, and save the value.
7Repeat steps 3 to 6 until all 3 parameter modes have been set.
Note
The pencil icon appears only after selecting the preset in step 3, however, until it is saved in step 6, the adjustment will not be applied.
Tip
Select “Reset” in step 4 to reset the default setting (off).
Smart mode allows you to choose one of 4 preset positions which you can then easily fine adjust.
1Select “SOUND” t
2Select the preset mode which you wish to set up.
3Adjust precisely the position.
12 4 Press (ENTER) to complete.
This mode is for those who wish to be more creative in shaping the sound. Measure the distance between your listening position and each speaker. You will need to input these distances for the correct delay(s) to be applied.
1Select “SOUND” t
2Select “Custom1,” “Custom2” or “Custom3” to store.
3Select the speaker position.
4Enter the distance between the speaker position and the listening position.
One click of (SEEK)
5Confirm your settings using the confirmation screen, and save the value.
“Custom1,” “Custom2” and “Custom3” appear with a pencil icon after saving, e.g.,
“Custom1 .”
6Repeat steps 3 to 5 until all speaker positions have been set.
Note
The adjustment will not be applied until it is saved in step 5.
Tips
•Select “Initialize” in step 3 to reset the default values.
•See the conversion table for cm and inch equivalents (page 23).