Getting Started

Resetting the unit

Before operating the unit for the first time, or after replacing the car battery or changing the connections, you must reset the unit.

Detach the front panel and press the RESET button with a pointed object, such as a ball-point pen.

RESET button

Note

Pressing the RESET button will erase the clock setting and some stored contents. Custom memory of HDEQ, DSO 3D and Intelligent Time Alignment (I-TA) will not be erased (page 11).

Setting the clock

The clock uses a 12-hour digital indication.

1Press (MENU).

2Press (GP/ALBM) +/– repeatedly until “SETUP” appears, then press

(ENTER).

3Press (GP/ALBM) +/– repeatedly until “Clock Adjust” appears, then press

(ENTER).

The clock adjustment display appears.

4Press (GP/ALBM) +/– repeatedly to set the hour and minute.

To move the digital indication, press (SEEK) –/+.

5After setting the minute, press

(ENTER).

The clock starts.

With the card remote commander

In steps 2 to 4: press M or m instead of the (GP/ALBM)

+/–; in step 4: press < or , instead of (SEEK) –/+.

Detaching the front panel

You can detach the front panel of this unit to prevent theft.

Caution alarm

If you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. The alarm will only sound if the built-in amplifier is used.

1Press (OFF).

The unit is turned off.

2Press (OPEN).

The front panel is flipped down.

3Slide the front panel to the right, then gently pull out the left end of the front panel.

1

2

Notes

•Do not drop or put excessive pressure on the front panel and display window.

•Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray.

4