Other functions

Changing the sound settings

Adjusting the sound characteristics — Balance/Fader/ Sub Woofer

You can adjust the balance, fader and subwoofer volume.

1Select a source, then press (SOUND) repeatedly to select the desired item.

The item changes as follows:

DSO 3D t I-TA t

Balance (left-right) t Fader (rear-front) t

Sub Woofer (subwoofer volume)*

*“ − ∞” is displayed at the lowest setting, and can be adjusted up to 20 steps.

2Rotate the VOL control dial to adjust the selected item.

After about 3 seconds, the setting is complete and the display returns to normal play/ reception mode.

With the card remote commander

In step 2, to adjust the selected item, press < or ,.

Adjusting menu items — MENU

1Press (MENU).

2Press (GP/ALBM) +/– repeatedly until the desired menu item appears, then press (ENTER).

The items changes as follows:

SETUP y DISPLAY y RECEIVE MODE y SOUND y LIST

3Press (GP/ALBM) +/– repeatedly until desired setting item appears, then press (ENTER).

The digital indication moves to the right (setting selection) side.

4Press (SEEK) –/+ to select the setting, then press (ENTER).

The setting is complete.

14

5Press (MENU).

The display returns to normal play/reception mode.

Note

Displayed items will differ, depending on the source and setting.

With the card remote commander

In steps 2 and 3: press M or m instead of (GP/ALBM) +/–; in steps 2, 3 and 4, press < or , instead of

(ENTER).

The following items can be set (follow the page reference for details):

“z” indicates the default settings.

SETUP

Clock Adjust (page 4)

Beep

To set “on” (z) or “off.”

RM (Rotary Commander)

To change the operative direction of the rotary commander controls.

–“NORM” (z): to use the rotary commander in the factory-set position.

–“REV”: when you mount the rotary commander on the right side of the steering column.

AUX-Audio*1

To turn the AUX source display “on” (z) or “off” (page 16).

DISPLAY

Auto Image

Auto Image mode automatically steps (every 10 seconds) through the display images.

–“off”: to not change the image automatically.

–“SA”: to step repeatedly through the display images of Spectrum analyzer mode.

–“Movie”: to step repeatedly through the display images of Movie mode.

–“All” (z): to step repeatedly through the display images in all display modes.

Information (Display Information)

To display the items (depending on the source, etc.) at the middle of the display while a image is displayed.

–“Simple”(z): to not display any items.

–“All”: to display all items.

–“Clear”: to have items automatically disappear. (Excluding digital indication.)

Demo*1 (Demonstration)

To set “off” or “on” (z).

Dimmer

To change the brightness of the display.

–“off”: to deactivate the dimmer.

–“Auto” (z): to dim the display automatically when you turn lights on.

–“on”: to dim the display.