Other functionsChanging the sound settingsAdjusting the sound characteristics

You can adjust the equalizer, DSO, bass, treble, balance, fader and subwoofer volume.

1Select a source, then press (SOUND) repeatedly to select the desired item.

The item changes as follows:

EQ7 t DSO t BAS (bass) t

TRE (treble) t BAL (left-right) t FAD (front-rear) t

SUB (subwoofer volume)*

*“ ∞” is displayed at the lowest setting, and can be adjusted up to 20 steps.

2Rotate the VOL control dial repeatedly to adjust the selected item.

After 3 seconds, the setting is complete and the display returns to normal play/reception mode.

Note

Adjust within 3 seconds of selecting the item.

With the card remote commander

In step 2: press < or , instead of the VOL control dial.

Adjusting the equalizer curve— EQ7 Tune

You can adjust and store the equalizer settings for different tone ranges.

1Select a source, then press (MENU).

2Rotate the SEEK control dial until “Sound” appears, then press (ENTER).

3Rotate the SEEK control dial until “EQ7 Tune” appears, then press

(ENTER).

4Rotate the SEEK control dial to select the desired equalizer type, then press

(ENTER).

5Rotate the SEEK control dial to adjust the desired volume level.

The volume level is adjustable in 1 dB steps, from –10 dB to +10 dB.

62Hz t 157Hz t 396Hz t 1.0kHz

t2.5kHz t 6.3kHz t 16kHz

Repeat steps 5 and 6 to adjust the equalizer curve.

The confirmation dialog appears after adjusting “16kHz” and pressing (ENTER).

7Rotate the SEEK control dial to select “YES,” then press (ENTER).

The setting is complete and the display returns to normal play/reception mode.

To restore the factory-set equalizer curve, press and hold (ENTER) in step 5 or 6, then rotate the SEEK control dial to select “YES.”

With the card remote commander

In steps 2, 3 and 5: press M or m instead of the SEEK

control dial; in steps 4 and 7: press < or , instead

of the SEEK control dial; in step 6: press < or , instead of (ENTER).

Adjusting menu items — MENU

1Press (MENU).

2Rotate the SEEK control dial until the desired menu item appears, then press (ENTER).

The items changes as follows:

Setup y Display y Receive Mode y Sound y Edit y List

3Rotate the SEEK control dial until desired setting item appears, then press (ENTER).

The digital indication moves to the right (setting selection) side.

4Rotate the SEEK control dial to select the setting, then press (ENTER).

The setting is complete.

5Press (MENU).

The display returns to normal play/reception mode.

Note

Displayed items will differ, depending on the source and setting.

With the card remote commander

In steps 2 and 3: press M or m instead of the SEEK control dial; in step 4, press < or , instead of the SEEK control dial.

continue to next page t

6Press (ENTER) to move to the next

frequency.

11

The frequency changes as follows: