Before operating the unit for the first time, or after replacing the car battery or changing the connections, you must reset the unit.
Detach the front panel and press the RESET button with a pointed object, such as a ballpoint pen.
RESET button
Note
Pressing the RESET button will erase the clock setting and some stored contents.
Setting the clockThe clock uses a
1Press (MENU).
2Rotate the SEEK control dial until “Setup” appears, then press (ENTER).
3Rotate the SEEK control dial until “Clock Adjust” appears, then press
(ENTER).
The clock adjustment display appears.
4Rotate the SEEK control dial to set the hour and minute.
To move the digital indication, press
(ENTER).
5After setting the minute, press
(ENTER).
The clock starts.
To display the clock during playback/reception, set “Clock on” (page 12).
With the card remote commander
In steps 2 to 4: press M or m instead of the SEEK
control dial; in step 4: press < or , instead of (ENTER).
Tip
You can set the clock automatically with the RDS feature (page 10).
DEMO modeWhen the unit is turned off, the clock is displayed first, then demonstration (DEMO) mode starts the demonstration display.
To cancel the DEMO mode, set to “Demo off” in menu (page 12) while the unit is turned off.
You can detach the front panel of this unit to prevent theft.
Caution alarmIf you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. The alarm will only sound if the
1Press (OFF).
The unit is turned off.
2Press 
.
The left side of front panel is released.
3Slide the front panel to the left, then gently pull out the front panel towards you.
(OFF)
2
1
Notes
•Do not drop or put excessive pressure on the front panel and display window.
•Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray.
Tip
When carrying the front panel, use the supplied front panel case.
4