Specifications

AUDIO POWER SPECIFICATIONS

POWER OUTPUT AND TOTAL HARMONIC DISTORTION

23.2watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 5% total harmonic distortion.

CEA2006 Standard

Power Output: 17 Watts RMS ⋅ 4 at 4 Ohms < 1% THD+N

SN Ratio: 82 dBA

(reference: 1 Watt into 4 Ohms)

CD Player section

Signal-to-noise ratio: 120 dB

Frequency response: 10 – 20,000 Hz

Wow and flutter: Below measurable limit

Tuner section

FM

Tuning range: 87.5 – 107.9 MHz

Antenna terminal: External antenna connector

Intermediate frequency: 10.7 MHz/450 kHz

Usable sensitivity: 9 dBf

Selectivity: 75 dB at 400 kHz

Signal-to-noise ratio: 67 dB (stereo), 69 dB (mono)

Harmonic distortion at 1 kHz: 0.5 % (stereo),

0.3 % (mono)

Separation: 35 dB at 1 kHz

Frequency response: 30 – 15,000 Hz

AM

Tuning range: 530 – 1,710 kHz

Antenna terminal: External antenna connector

Intermediate frequency: 10.7 MHz/450 kHz

Sensitivity: 30 µV

Power amplifier section

Outputs: Speaker outputs (sure seal connectors)

Speaker impedance: 4 – 8 ohms

Maximum power output: 52 W ⋅ 4 (at 4 ohms)

General

 

Outputs:

 

Audio outputs terminal (front/rear)

 

Subwoofer output terminal (mono)

 

Power antenna relay control terminal

 

Power amplifier control terminal

 

Inputs:

 

Telephone ATT control terminal

 

Illumination control terminal

 

BUS control input terminal

 

BUS audio input/AUX IN terminal

 

Remote controller input terminal

 

Antenna input terminal

 

Tone controls:

 

Bass: ±10 dB at 62 Hz

 

Treble: ±10 dB at 16 kHz

 

Loudness:

16

+8 dB at 100 Hz

+2 dB at 10 kHz

 

Power requirements: 12 V DC car battery (negative ground)

Dimensions: Approx. 178 ⋅ 50 ⋅ 182 mm (7 1/8 ⋅ 2 ⋅ 7 1/4 in) (w/h/d)

Mounting dimensions: Approx. 182 ⋅ 53 ⋅ 161 mm (7 1/4 ⋅ 2 1/8 ⋅ 6 3/8 in) (w/h/d)

Mass: Approx. 1.2 kg (2 lb 10 oz)

Supplied accessories:

Card remote commander: RM-X153

Parts for installation and connections (1 set) Front panel case (1)

Optional accessories/equipment:

BUS cable (supplied with an RCA pin cord): RC-61 (1 m), RC-62 (2 m)

CD changer (10 discs): CDX-757MX

CD changer (6 discs): CDX-T69

MD changer (6 discs): MDX-66XLP

Source selector: XA-C30

AUX-IN selector: XA-300

US and foreign patents licensed from Dolby Laboratories.

Note

This unit cannot be connected to a digital preamplifier or an equalizer which is Sony BUS system compatible.

Design and specifications are subject to change without notice.

•Lead-free solder is used for soldering certain parts. (more than 80 %)

•Halogenated flame retardants are not used in the certain printed wiring boards.

•Halogenated flame retardants are not used in cabinets.

•Packaging cushions do not use polystyrene foam.

Troubleshooting

The following checklist will help you remedy problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures.

General

No power is being supplied to the unit.

•Check the connection. If everything is in order, check the fuse.

•If the unit is turned off and the display disappears, it cannot be operated with the remote commander. t Turn on the unit.

The power antenna does not extend.

The power antenna does not have a relay box.