Tuner section
FM
Tuning range: 87.5 – 108.0 MHz
Aerial terminal: External aerial connector
Intermediate frequency: 10.7 MHz/450 kHz
Usable sensitivity: 9 dBf
Selectivity: 75 dB at 400 kHz
Harmonic distortion at 1 kHz: 0.5 % (stereo),
0.3% (mono) Separation: 35 dB at 1 kHz Frequency response: 30 – 15,000 Hz
MW/LW
Tuning range:
MW: 531 – 1,602 kHz
LW: 153 – 279 kHz
Aerial terminal: External aerial connector
Intermediate frequency: 10.7 MHz/450 kHz
Sensitivity: MW: 30 µV, LW: 40 µV
Power amplifier section
Outputs: Speaker outputs (sure seal connectors)
Speaker impedance: 4 – 8 ohms
Maximum power output: 50 W ⋅ 4 (at 4 ohms)
General
Outputs:
Audio outputs terminal (rear)
Power aerial relay control terminal
Power amplifier control terminal
Inputs:
Telephone ATT control terminal
Aerial input terminal
Tone controls:
Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at 1 kHz (XPLOD)
High: ±10 dB at 10 kHz (XPLOD) Power requirements: 12 V DC car battery
(negative earth)
Dimensions: Approx. 178 ⋅ 50 ⋅ 176 mm (w/h/d)
Mounting dimensions: Approx. 182 ⋅ 53 ⋅ 161 mm
(w/h/d)
Mass: Approx. 1.2 kg
Supplied accessories:
Parts for installation and connections (1 set) Front panel case (1)
Optional accessory:
Card remote commander:
US and foreign patents licensed from Dolby Laboratories.
Design and specifications are subject to change without notice.
•
•Halogenated flame retardants are not used in the certain printed wiring boards.
•Halogenated flame retardants are not used in cabinets.
•Packaging cushions do not use polystyrene foam.
The following checklist will help you remedy problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures.
General
No power is being supplied to the unit.
•Check the connection. If everything is in order, check the fuse.
•If the unit is turned off and the display disappears, it cannot be operated with the remote commander.
t Turn on the unit.
The power aerial does not extend.
The power aerial does not have a relay box.
No sound.
•The volume is too low.
•The ATT function is activated, or the Telephone ATT function (when the interface cable of a car telephone is connected to the ATT lead) is activated.
•The position of the fader control (FAD) is not set for a
No beep sound.
•The beep sound is cancelled (page 9).
•An optional power amplifier is connected and you are not using the
The contents of the memory have been erased.
•The RESET button has been pressed. t Store again into the memory.
•The power connecting lead or battery has been disconnected.
•The power connecting lead is not connected properly.
Stored stations and correct time are erased. The fuse has blown.
Makes noise when the position of the ignition key is switched.
The leads are not matched correctly with the car’s accessory power connector.
The display disappears from/does not appear in the display window.
•The display disappears if you press and hold
(OFF).
t Press and hold (OFF) again until the display appears.
•The connectors are dirty (page 12).
continue to next page t
13