Step 3: Presetting radio stations — Preset

The system can store a total of 30 preset stations (20 for FM and 10 for AM). This section explains how to tune in stations and preset them.

6

2

4

3

1

5

7

1Press FUNCTION repeatedly until “TUNER” appears.

2Press TUNER/BAND to select FM or AM.

3Press TUNING MODE repeatedly until “AUTO” appears.

4Press j/J.

The frequency changes as the system scans for a station. Scanning stops automatically when a station is tuned in. At that time, “TUNED” and “STEREO” (for stereo programs only) appear.

AUTO

STEREO

FM1005TUNED

MHz

5 Press MEMORY.

A preset number flashes.

PRESET

STEREO

1FM1005TUNED

MHz

6 Press l/L repeatedly to select the preset number that you want.

PRESET

STEREO

3FM1005TUNED

MHz

7 Press ENTER.

The station is stored to the selected preset number.

8 Repeat steps 2 through 7 to preset other stations.

To tune in a weak station

In step 3, press TUNING MODE repeatedly until “AUTO” and “PRESET” disappear, then press j/J repeatedly to tune in the station.

To change the preset number

Start over from step 2.

Tip

The preset stations are saved in the system’s memory for about a day even if you disconnect the power cord or a power failure occurs.

To change the AM tuning interval (not applicable on the European and Middle Eastern models)

The AM tuning interval is factory-preset to 9 kHz (or 10 kHz on North American model). To switch the AM tuning interval, tune in any AM station first, then turn off the system. Pressing TUNER + on the unit down, turn the system back on. When you change the interval, all the AM preset stations are erased. To change back to the original interval, repeat the same procedure for CMT-CP2W. For CMT-CP2WA, tune in any AM station first, then turn off the system. Pressing TUNER – down, turn the system back on.

Started Getting

7