•No cassette is loaded. Load a cassette.
•The tab has been removed from the cassette. Cover the broken tab with adhesive tape (page 29).
•The tape has wound to the end.
Optional componentsThere is no sound.
•Refer to General item “There is no sound.” (page 24) and check the condition of the system.
•Connect the component properly (page 22) while checking:
–if the cords are connected properly.
–if the cord plugs are firmly inserted all the way.
•Turn on the connected component.
•Refer to the operating instructions supplied with the connected component and start playing.
•Press FUNCTION repeatedly to select “MD” or “VIDEO” (page 23).
The sound is distorted.•Set the volume of the connected component lower.
Messages
One of the following messages may appear or flash in the display during operation.
CD/MP3NO DISCThere is no disc in the player.
NO STEPAll of the programmed tracks have been erased.
OVERYou have reached the end of the disc while pressing
Mduring playback or pause.
PUSH STOPYou pressed PLAY MODE during playback.
STEP FULLYou tried to program 25 or more tracks (steps).
Tuner
COMPLETEThe preset operation ended normally.
If the system still does not operate properly after performing the above measures, reset the system as follows:
1Disconnect the mains lead.
2Reconnect the mains lead.
3Press ?/1 to turn on the system.
4Press TAPE x, CD x and ?/1 on the unit.
The system is reset to the factory settings. You should set the settings you made, such as the preset stations, clock, and timer.
You cannot record the tape because the tab has been removed from the cassette.
NO TAPEThere is no tape in the tape deck.
TimerPUSH SELECTYou tried to set the clock or timer during timer operation.
SET CLOCKYou tried to select the timer with the clock not set.
SET TIMERYou cannot select the timer function when the Play Timer or Timer Recording are not set.
TIME NGPlay Timer or Timer Recording start and end times are set to the same time.
continued