Press ENTER.
The station is stored.
Setting presets through manual tuning
1 Press TUNER (TUNER/BAND on the remote) repeatedly to select “FM” or “AM”.

2 Turn and hold TUNING +/– (or press and hold TUNING + or TUNING – on the remote) repeatedly to tune in the desired station.

3 Press TUNER MEM (TUNER MEMORY on the remote).

The preset number starts flashing.

The stations are stored from preset number 1.

To erase all preset stations

1Press and hold TUNER MEM (TUNER MEMORY on the remote) until “ERASE” and “PRESET” appear alternately.

2Press ENTER.

All preset stations are cleared.

To change the AM tuning interval (except for the European model)

Disconnect the power cord from the wall outlet first, and then set the AM FREQ STEP switch at the rear to 9 kHz or 10 kHz.

Tip

The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs.

Tuner

-

Preset number

4

5 Repeat steps 1 to 4 to store other stations.
Other Operations

To

Do this

Tune in a station with a

Follow the procedure

weak signal

described in “Setting

 

presets through manual

 

tuning”.

 

 

Change the preset

Start over from step 1.

number

 

Listening to the radio

You can listen to a radio station either by selecting a preset station, or by manually tuning in the station.

Listening to a preset station
— Preset Tuning

Preset radio stations in the tuner’s memory first (see “Presetting radio stations” on page 10).

1 Press TUNER (TUNER/BAND on the remote).

2 Press PRESET + or – repeatedly to tune in the desired preset station (or RDS station name*).

The preset number appears in the display for a few seconds.

When only one station is preset, only that

Set another station to an exsisting preset number

Start over from step 1. After step 3, press PRESET + or – repeatedly to select the preset number where you want to store the other station and then press

ENTER.

station is tuned.

* European model only.

continued

11GB