Presetting radio stations (continued)

Other operations

To

Do this

Tune in a weak

Follow the procedure

station

described in “Setting presets

 

through manual tuning”.

 

 

Cancel presetting

Press MENU/NO on the

 

remote in step 5 or 6.

 

 

Change the preset

Start over from step 1.

number

 

 

 

To change the AM tuning interval (not applicable on the European model)

The AM tuning interval is factory-preset to 9 kHz (or 10 kHz for some areas). To switch the AM tuning interval, tune in any AM station first, then turn off the system. Pressing and holding down FUNCTION, turn the system back on. When you change the interval, all the AM preset stations are erased. To change back to the original interval, repeat the same procedure.

Tips

•The preset stations are saved in the system’s memory for about a day even if you disconnect the power cord or a power failure occurs.

•You can label the preset stations (see page 17).

•To improve the reception, adjust the supplied antennas or connect an external antenna.

Listening to the radio

You can listen to a radio station either by selecting a preset station or by manually tuning in a station.

Listening to a preset station
— Preset Tuning

Preset radio stations in the tuner’s memory first (see “Presetting radio stations” on page 15).

1 Press TUNER/BAND to select “FM” or “AM”.

2 Press PLAY MODE/TUNING MODE repeatedly until “PRESET” appears in the display.

3 Press TUNING + or – repeatedly to select the desired preset station (or station name* or RDS station name**).

*The station name appears only if you have labelled the station (see “Labelling the preset stations ” on page 17).

**European model only.

To select a desired preset number using the numeric buttons on the remote

Press numeric buttons instead of performing step 3.

To enter preset number over 10, press >10 and enter the corresponding digits. To enter 0, press 10/0 instead.

Example:

To enter preset number 20, press >10, then 2 and 10/0.

Listening to a non-preset radio station
— Manual Tuning

1 Press TUNER/BAND to select “FM” or “AM”.

2 Press PLAY MODE/TUNING MODE repeatedly until “AUTO” and “PRESET” disappear from the display.

3 Press TUNING + or – repeatedly to tune in the desired station.

Tips

•To improve the reception, adjust the supplied antennas or connect an external antenna.

•If there is static during an FM broadcast, press FM MODE on the remote until “MONO” appears in the display. The broadcast will no longer be in stereo, but the reception will improve.

•In step 2, press PLAY MODE/TUNING MODE repeatedly until “AUTO” appears in the display, and then press TUNING + or –. The frequency indication changes and the scanning stops when the system tunes in a station (Automatic Tuning).

16GB