Turn on the system.

Replacing the battery in

the remote

1 Slide out and remove the battery case.2 Insert a new lithium battery CR2025 with the + side facing up.

a lithium battery CR2025

3 Slide the battery case back in.

Tip

When the battery no longer operates the remote, replace the battery with a new one.

Note

If you are not going to use the remote for a long time, remove the battery to avoid damage caused by corrosion from battery leakage.

Notes on lithium battery

•Keep the lithium battery out of the reach of children.

Should the battery be swallowed, immediately consult a doctor.

•Wipe the battery with a dry cloth to assure a good contact.

•Be sure to observe the correct polarity when installing the battery.

•Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur.

WARNING

Battery may explode if you mistreated.

Do not recharge, disassemble or dispose of in fire.

Setting the clock

1

2 Press CLOCK/TIMER SET on the remote.

3 Press .or >on the remote repeatedly to set the day, and then press ENTER/YES or CURSORt on the remote.

The hour indication flashes.

4 Press .or >on the remote repeatedly to set the hour, and then press ENTER/YES or CURSORt on the remote.

The minute indication flashes.

5 Press .or >on the remote repeatedly to set the minute, and then press ENTER/YES on the remote.

If you make a mistake

Press TCURSOR or CURSORton the remote repeatedly until the indication you want to change (day, hour, minute) flashes, and then change the setting.

To adjust the clock

1 Press CLOCK/TIMER SET on the remote.

2 Press .or >on the remote repeatedly until “CLOCK SET?” appears in the display, and then press ENTER/YES on the remote.

3 Do the same procedures as steps 3 to 5 above.

10GB