Tuner

Scanning DAB stations

Before you can receive DAB, you must register the contents of broadcasts (service components) so that they can be received by the DAB tuner using the DAB Automatic Scan procedure.

DAB Automatic Scan

DAB Automatic Scan starts automatically only when you turn on the system for the first time after you purchase the system.

If you want to use the DAB Automatic Scan again, perform the procedure below.

1 Press DAB AUTO SCAN on the unit.

“DAB Auto Scan? Push DAB” appears.

2 Press DAB on the unit.

Scanning begins. “DAB Auto Scan” appears. Depending on the DAB services available in your area, scanning may take a few minutes.

When scanning is complete, available service component list is created.

Notes

•If your country or region does not support DAB broadcast, “No Service” appears.

•Do not press any button on the unit or supplied remote during DAB Automatic Scan. Scanning is interrupted and service component list may not be created properly. In this case, perform the DAB Automatic Scan again.

•If you move to another area, repeat this procedure to store the stations for your new area.

•This procedure clears all previously stored presets.

•This procedure does not create any presets.

To move system location

When you wish to move the system to a new location, to preserve your own DAB settings, make sure the clock display* appears when the system is powered down, before unplugging the mains lead and DAB lead aerial.

*In Power Saving Mode, make sure the clock display disappears.

Presetting radio stations

You can preset up to 20 DAB stations, 20 FM stations and 10 AM stations. You can then tune in any of those stations simply by selecting the corresponding preset number.

Automatic tuning preset

You can automatically tune in all of the service components or stations that can be received in your area and then store them.

1 Press TUNER/BAND (or FUNCTION repeatedly) to switch the function toTUNER.2 Press TUNER/BAND repeatedly to select “DAB”, “FM” or “AM”.

You can also use the DAB button to select DAB directly.

3 Press TUNING MODE repeatedly until “AUTO” appears in the display.4 Press + or – (or TUNING + or – on the unit).

Service component list is played downward (DAB) or the frequency changes as the system scans for a station (FM/AM). Scanning stops automatically when a station is tuned in. At that time, “TUNED” and “STEREO” (for stereo program only) appear.

If “TUNED” does not appear and the scanning does not stop

Set the frequency of the desired radio station as described in steps 3 and 4 of “Manual tuning preset (FM/AM bands only)” (page 14).

Manual tuning is not available for DAB.

continued

Tuner
13GB