•Make sure that you tune in an FM station.
•Select a stronger FM station.
The appropriate display or information does not appear.•Contact the radio station and find out whether or not they actually provide the service in question. The service may be temporarily out of order.
The tuner malfunctions.•The microprocessor in the tuner has malfunctioned. Turn off the tuner, then turn it on again.
“TUNED” does not appear in the display (DAB only).•Check all aerial connections, then perform the DAB Automatic Scan (page 13).
•The current DAB service is not available. Press + or – (or TUNING + or – on the unit) to select a different service.
•If you have moved to another area, some services/ frequencies may have changed and you may not be able to tune into your usual broadcast. Perform the DAB Automatic Scan procedure to
•Check all aerial connections, then perform the DAB Automatic Scan (page 13).
Service Component label, Ensemble label and DLS information do not appear correctly.
•The characters that can be displayed by this system are as follows:
–A to Z
–a to z
–0 to 9
–! " # $ % & ' ( ) * + ,
Other characters may not be displayed correctly.
Tape deckThe tape does not record or play, or there is a decrease in sound level.•The heads are dirty. Clean them (page 30).
•The record/playback heads are magnetized. Demagnetize them (page 30).
The tape does not erase completely.•The record/playback heads are magnetized. Demagnetize them (page 30).
•The capstans in the tape deck are dirty. Clean them (page 30).
Noise increases or the high frequencies are erased.•The record/playback heads are magnetized. Demagnetize them (page 30).
The tape does not record.•No cassette is loaded. Load a cassette.
•The tab has been removed from the cassette. Cover the broken tab with adhesive tape (page 30).
•The tape has wound to the end.
Optional componentsThere is no sound.
•Refer to General item “There is no sound.” (page 25) and check the condition of the system.
•Connect the component properly (page 24) while checking:
–if the cords are connected properly.
–if the cord plugs are firmly inserted all the way.
•Turn on the connected component.
•Refer to the operating instructions supplied with the connected component and start playing.
•Press FUNCTION repeatedly to select “AUDIO IN” (page 24).
The sound is distorted.•Set the volume of the connected component lower.
If the system still does not operate properly after performing the above measures, reset the system as follows:
Use buttons on the unit for the operation.
1Disconnect the mains lead.
2Reconnect the mains lead.
3Press ?/1 to turn on the system.
4Press x and ?/1 at the same time.
The system is reset to the factory settings. You should set the settings you made, such as the preset stations, clock, and timer.